My New 2019 Sweetwater 2286 SFL / 150 Suzuki

I have the same color 2286SB with the same Suzuki 150
one question, my motor is mounted at the lowest bolt location and I feel riding to low in the water.
What bolt position is yours mounted?
mine will do 39mph but the draft is quite high.

thanks for any information 

What shaft length is your 150 hp ( 20" long shaft or 25 Ex Long shaft)?  I'm running a 20" 115HP on a Sweetwater 2186  and had the same engine on a 2013  2286 and can't keep the prop from blowing out unless the trim is all the way down.  I lowered the motor to the lowest bolt hole ( the top) and I had the same problem on both boats.  I'm running a 3 blade 13.5 X 15pitch cupped.  i can get to 30MPH with more rpm left, but if I trim up barely, try to turn, or apply more throttle, the prop starts to slip and I get nothing out of the last 1000 rpm's.  Granted, 30 out of a 115 hp and a 21' twin tube ( not a tri toon) is pretty good, but what good is it if you can't turn it?

I have the exact setup. My boat was delivered on the lowest bolt setting also. I had it raised 2 holes and the ride is much drier in the rear with less splash and drag. Cavitation has never occurred.