-
Mounting the depth/fish finder
I would like to mount my new GPS/depth/fish locator on the LH dash panel above the radio but I'm not sure there is enough room to mount it. I need 4 13/16" high x 9 3/16 wide. Since my boat is 1000 miles away under shrink wrap I am hoping that someone measure theirs and let me know if there is enough room to do the…
-
Speedometer not working on 2014 Sweetwater 2086
I'm not sure if this is the correct forum, or if I should find a Yamaha outboard forum The speedometer on my recently purchased, used, 2014 Sweetwater pontoon, model SW2086C3 pontoon is not working. I don't find any transducer below the water line. The rubber tube coming from the speedometer appears to go back to the front…
-
Repairing a plastic gas tank
I really screwed up. I have a 2014 2086 Sweetwater pontoon. I was installing a galvanized mesh screen to keep muskrats from getting into the transom well and chewing the wiring harness. (It's happened to three of my neighbors on the lake). I drilled several 1/8th inch holes in the aluminum transom and then drilled one…
-
fuse/breaker
where is the main fuse and or breaker located on 2014 Sweetwater?
-
Help! New Mercury 150hp setup on SWPE
I am beyond frustrated right now trying to get setup right on my 2017 Sweetwater Premium 255SB (2 25" tubes, no underskin or strakes). The boat has a new 150hp Mercury Four Stroke and I cannot get the motor into its recommended RPM range at WOT. Originally the motor had a 14.5 dia x 15 pitch Vengeance prop on it. Motor…
-
I have a 2002 Sweetwater Challenger 180 EX and my rear navigation light on my bimini top was not
there so Is there a generic light that will work or where do I order one? Thank you...Rich
-
gas tank repair
I really screwed up. I have a 2014 2086 Sweetwater pontoon. I was installing a galvanized mesh screen to keep muskrats from getting into the transom well and chewing the wiring harness. (It's happened to three of my neighbors on the lake). I drilled several 1/8th inch holes in the aluminum transom and then drilled one…
-
Speed with 2 log Pontoons
-
New Pontoon Purchase
All, this is my first post, first boat purchase so i bought a 2012 sweetwater, im trying to figure out what model of the boat it is if anyone might be able to help i dont see any markings anywhere on a model number, i havent measured it or anything here is a number i was able to find stamped on the pontoon on the underside…
-
MOORING COVER
I NEED A NEW COVER FOR MY 2007 SWEETWATER PONTOON BOAT..MODEL 2486. ANY HELP WOULD BE WELCOMED.THX.
-
Performance Question?
Hello all i just acquired a 2012 sweetwater 2086 and it has a Yamaha 70hp (this is my first boat) what kind of speeds can i expect out of this thing? I had 3 adults and 2 6 yr old kids on it for the maiden voyage yesterday evening and 16mph was about max in calm waters
-
2009 Aqua Patio seat trim piece for speaker
Hello, Is it possible to get a replacement speaker trim piece for a 2009 Aqua Patio 240 RE. I have attached a picture to help with my description. Thank you, Dave Fitzgerald
-
Lots of little things wrong with our 2017 AP 235SB - is this typical?
I bought my first new boat in 2006 - a Yamaha SX230 - and DID NOT HAVE A SINGLE WARRANTY ISSUE. My second new boat, a 2017 AP 235SB is a different story. -pin hole in the bimini -speedometer is off by 10mph -strap missing from chaise lounge trash compartment -door latch busted on cockpit storage -snap was broken on the…
-
Boat cover and Bimini
Hi we have a 2014 Sanpan 2500LE. The front of the full morring cover and Bimini top are very loose. I wish I had contacted the dealer about this when we purchased the boat. Would this be something covered under warranty? There's also a miss aligned snap in the front of the morring cover.
-
PARTS
Were do I find original parts for my sweet water.