-
Cradle versus Slings
I have a AP 240SL tri-toon with 150 hp Yamaha. Bought a new home at Padre Island TX on a salt water canal. Boat house has slings. Is it ok to use slings for this boat or should a get a cradle?
-
Looking for information on advantages of larger motor on 2286 Godfrey
I am new to pontooning. We purchased a 2017 Sweetwater 2286 with a 20 hp due to the state park that we normally boat in. My question is, if we go to a bigger motor, how much additional speed should be attainable? We currently max out between 9 - 11. Can anyone give me some instances that they have experience please.
-
Happy Thanksgiving
-
parts for sea ryder paddle boat
I seen someone asked about parts and I have parts for a 11 ft paddle boat but I am new here and don't know how this works
-
Replacement Cover
We have a 1987 Sweetwater 2420 - and need a replacement cover. No matter what online site I go to, they all seem to just offer a cover that will fit a boat this size, nothing custom or specifically intended for the Sweetwater. When you have purchased a replacement cover, what manufacturer have you found to be of good…
-
Mounting the depth/fish finder
I would like to mount my new GPS/depth/fish locator on the LH dash panel above the radio but I'm not sure there is enough room to mount it. I need 4 13/16" high x 9 3/16 wide. Since my boat is 1000 miles away under shrink wrap I am hoping that someone measure theirs and let me know if there is enough room to do the…
-
Speedometer not working on 2014 Sweetwater 2086
I'm not sure if this is the correct forum, or if I should find a Yamaha outboard forum The speedometer on my recently purchased, used, 2014 Sweetwater pontoon, model SW2086C3 pontoon is not working. I don't find any transducer below the water line. The rubber tube coming from the speedometer appears to go back to the front…
-
fuse/breaker
where is the main fuse and or breaker located on 2014 Sweetwater?
-
gas tank repair
I really screwed up. I have a 2014 2086 Sweetwater pontoon. I was installing a galvanized mesh screen to keep muskrats from getting into the transom well and chewing the wiring harness. (It's happened to three of my neighbors on the lake). I drilled several 1/8th inch holes in the aluminum transom and then drilled one…
-
Speed with 2 log Pontoons
-
New Pontoon Purchase
All, this is my first post, first boat purchase so i bought a 2012 sweetwater, im trying to figure out what model of the boat it is if anyone might be able to help i dont see any markings anywhere on a model number, i havent measured it or anything here is a number i was able to find stamped on the pontoon on the underside…
-
MOORING COVER
I NEED A NEW COVER FOR MY 2007 SWEETWATER PONTOON BOAT..MODEL 2486. ANY HELP WOULD BE WELCOMED.THX.
-
Performance Question?
Hello all i just acquired a 2012 sweetwater 2086 and it has a Yamaha 70hp (this is my first boat) what kind of speeds can i expect out of this thing? I had 3 adults and 2 6 yr old kids on it for the maiden voyage yesterday evening and 16mph was about max in calm waters
-
Third tube supposed to have holes drilled into it?
Just got my new 2286 SW DL Triple Tube and it squats a fair amount in the rear. I'm really wishing this thing would sit more level. Dealer said it's because of the larger tubes and the 150hp motor. I looked at some pictures from the day 1 when it was still on the trailer and I'm noticing holes drilled into the bottom of…
-
Sanpan quality issues
Hi All - looking for a little advice. I bought a new Sanpan 2500 2 years ago that is just riddled with quality issues, including plumbing, seats falling through, radio broken, helm shaking apart, instruments falling out - the list goes on and on (over 30 issues). I have been in touch with Bennington/Godfrey directly, and…