-
2015 Sweetwater 240 SD... requesting pics of under your console please
My console was smashed by a tree a few months ago. After getting it looking nice again I have the gauges hooked up but the left gauge has RPM/Tilt/GAS.... only the gas guage works. Can someone post a pic of their wires coming out from below the throttle. Also have a 4 prong that plugs into nothing... motor is 150HP Yamaha.…
-
Console Windshield for 2008 Sweetwater Tuscany 21'
Any suggestions on where to find a windshield? Does anyone have the dimensions or part number of the windshield (i.e., LxW)? I found some possible windshields, but need to confirm it is the right fit. Thxs!
-
Fuse panel question
I have 2000 Parti Kraft pontoon my lights dont work. Which fuse(s) in the fuse panel controls the lights I dont have a diagram of the fuse panel
-
6" screw-in access cover - 2007 Sweetwater Tuscany 1880
Just bought my first pontoon boat: In the battery and fuel fill area at the stern of the boat, there is a 6" access port on the deck. Is this direct access to the fuel tank? I smell gas fumes in the area but I cannot tell if I'm smelling the fuel fill which is right above this access port.
-
Vented caps or NON-Vented Caps on Toons
I found maybe 1/2 gal of water in one toon. After testing repeatedly it holds 2lbs air consistently (24hrs) so therefore no leak. My theory is the vented caps could be allowing condensation or water in! Most Mfg do not have vented caps. Doesn't it make sense to use NON-vented caps moving forward?? IF there was a small leak…
-
Talon SS4 Prop for VF115 SHO on Sweetwater 2286 SBX (repost )
My first post: I just bought a 2021 2286 sbx with a vmax 115, it came with an aluminum 135/8" x 14". With this prop, 4 people on board, no trim, the rpm was 6400 and climbing. I throttled back @6400 as the max rpm is 6300. Speed was only 26.6 mph (very underwhelming for a tritoon boat), no pull from 4000-6400 rpm. I am…
-
Corner Caps
Any guidance on where I could find the front corner caps of the decking trim? Looking for 1, potentially 2 of the brushed aluminum 9.5inch corner caps for a 2014 Godfrey Sweetwater - but not having any luck on my own trying to find any of these. Appreciate any help.
-
Locking gas cap?
I have a 2020 Monaco 215C. It has the newer hinged, affixed gas cap. Recently, some neighbors on our lake have been having some gas siphoned off in the pre-dawn hours, possibly by trolling bass boats creeping around the shorelines. Anyhow, looking for fuel system supplier name or product numbers in order to determine if…
-
Lowrance Fuse
Silly question here. I have a 2020 SW 160c and my Lowrance Hook will not turn on, all other accessories work fine. I have found the fuses for the stereo, ignition, etc but following the cables under the console cannot find the fuse for the fish/depth finder. Very frustrating. Any Tips?
-
Maximum motor rating 1994 Sanpan 22'
Does anyone know the maximum motor rating for a 1994 Sanpan 22' pontoon? Looking to repower but this boat was totally redone and no longer has the coast guard rating plaque.
-
copper sulfate
My pontoon dock and channel is very bad with water weeds. Can I use copper sulfate to kill the weeds with out corroding my pontoons. I have a 2020 Godfrey Sweetwater. My first use the motor water inlet clogged in less that 100 yards. Looking for a suggestion, Thank You
-
Seeking Mooring Cover for 2007 Sanpan 2500FE
We just purchased this boat and sadly it did not come with the mooring cover. The snaps are all installed under the rails, so it obviously had one at one time. It came out of California, so I suspect sun rot took it. Now that it's in Oregon, we'll treat it more gently. That being said, either I can find one on a forum like…
-
Impact + 29 inch toon
Anyone have any experience with the new 29 inch center toon with 27 outside ones???
-
My 2011 Godfrey Sweetwater 2086 won't go over half speed at times, what's up?
I can turn the engine off and back on and it speeds back up. It has a BF50 hp Honda motor.
-
how to I get to fuel line on the tank?
Does the transom have to be dropped? second question..to replace the end on the tank fill do i have to remoce other vent lines in order to get new fuel line through **** in floor?